CFCs are 1000-15000 times powerful as compared to greenhouse gas such as CO2.
Chlorofluorocarbons are present in less amount or less abundant than carbon dioxide gas in the atmosphere but they are 10,000 times more powerful as a greenhouse gas.
These CFCS gases can remain in the atmosphere for more than 45 to 100 years. CFCS gases greatly damaged the ozone layer by reacting with it that leads to increase in the diseases such as skin cancer so we can conclude that CFCs are more powerful as compared to carbondioxide gas.
Learn more: https://brainly.com/question/24994753
What is the air pressure on top of the mountain?
Explanation:
At sea level, the atmospheric pressure would be a little over 100 kPa (one atmosphere or 760 mm Hg). If we climb to the top of Mount Everest (the highest mountain in the world at 29,029 feet or 8848 meters), the atmospheric pressure will drop to slightly over 30 kPa (about 0.30 atmospheres or 228 mm Hg).
Hope it is helpful for you
See if you can complete the following table using only what is on this page. Hint: Two of the entries are for the same element.
Element
Symbol
Nuclear
Symbol
Atomic Mass
Protons Neutrons Electrons
Number Number
83 Cu
29
Ga
67
31
29
36
Answer:
See attached picture.
Explanation:
Hello there!
In this case, according to the given information, it is possible to complete the table by knowing that the atomic number is the same to the number of protons equals those of electrons and that the neutrons are calculated by subtracting the atomic mass and the protons; thus, we are able to obtain the result as shown on the attached picture.
Best regards!
75.0 grams of MgCl, is dissolved in 500.0 g of water, density 1.00 g/ml. What is the MOLALITY of this solution?
es -)
A)
0.50 m
B)
1.00 m
C)
1.58 m
D)
2.02 m
Answer:
C
Explanation:
Check it. So u can know it
Draw the major organic product formed in the reaction. (The reaction stoichiometry is 1 mol reactant: 1 mol Br2 .)
Answer:
Explanation:
The treatment of aldehyde or ketone in the presence of acetic acid with one mole of bromine results in ∝-halo aldehyde or ketone. However, the bromination of ketone undergoes acidic conditions. Hence, the reaction of the ketone with Bromine resulting in the Major Product is shown in the image attached below.
How do gases exert pressure?
Explanation:
the pressure exerted by the gas is due to the random motion of particles in the gas. Gases have weak intermolecular forces and the particles in continuous random motion and these particles collide with the walls of the container. This collisions with the walls of the container exerts pressure on the gas
Calculate the number of moles in 40g of Al(OH)3
Answer:
oo it's from chemistry
Explanation:
I am little week in chemistry so sorry
the color of an object that absorbs all colors except red
Answer:
The color black absorbs most colors, while white reflects most colors.
what is a chemical bond?
how ate chemical bond different from each other?.
help now im not trying to fail
Answer:
i cant see the whats in the picture
Describe the four levels of heat preservation used by the food industry.
What would
happen to the
vultures if the
gazelle
decreased?
Answer: If the gazelle population starts to decrease this could lead to some vultures not having enough food to eat
Explanation: This explains the obvious outcome of what would happen.
Hope you do well with what your doing :)
Mark as Brainliest please :)
How many molecules of methane gas (CH4) are in 32.1 grams of methane
Answer:
There are 1.8021⋅1024 molecules of CH4 in 48 grams of CH4 .
Explanation:
hope it helps you
follow me for more
I'm willing to help
SO2 + PCL5 → SOCL2 + POCL3
What mass of SOCL2 is produced when 1.35 g SO2 react with 2.75 g PCL5
Answer:
2.34
Explanation:
Knives should be stored in cluttered drawers.
True or false
Is anyone good at chemistry if so can someone help me please ?
(NO LINKS)
So, what's shown here is the ion product of pure water: that is, the product of the concentrations of hydronium and hydroxide ions in pure water at 25 °C. By this relation, if you know the [H₃O⁺], you can calculate the [OH⁻], and vice-versa.
Since [H₃O⁺] × [OH⁻] = 1.0 × 10⁻¹⁴, [OH⁻] = (1.0 × 10⁻¹⁴)/[H₃O⁺].
Substituting the given [H₃O⁺] as 1.25 × 10⁻² M:
[OH⁻] = (1.0 × 10⁻¹⁴)/(1.25 × 10⁻² M) = 8.0 × 10⁻¹³ M.
Which of the following galaxies do not have a regular structure?
A. Elliptical and barred spiral galaxies
B. Irregular and elliptical galaxies
C. Spiral galaxies
D. Irregular galaxies
Answer: D
Explanation: Irregular galaxies
Answer:
Your answer is D
Explanation:
Irregular galaxies do not have a regular structure.
Please help me outttt
Answer:
4.) 9, 1, and 4 5.) 4, 1, and 4
Explanation:
I am not quite sure about this because I cannot remember if the coefficient (the number before the elements) is applied to every element in the compound. If it is then your number of atoms are as follows: CORRECTION: you do not have to apply the coefficient to every element only the one that is after it. So when you back and fix the error your number of atoms will be as follows:
number 4
H: 9
P: 1
O: 4
number 5:
H: 4
S: 1
O: 4
you can calculate the number of atoms present in this compound by multiplying the coefficient and the subscripts of each atom.
hope this helped you :)
What is the energy of an electron in a Li+ ion when an electron moves from n = 2 to n =3?
Answer:
The question wants you to determine the energy that the incoming photon must have in order to allow the electron that absorbs it to jump from
n
i
=
2
to
n
f
=
6
.
A good starting point here will be to calculate the energy of the photon emitted when the electron falls from
n
i
=
6
to
n
f
=
2
by using the Rydberg equation.
1
λ
=
R
⋅
(
1
n
2
f
−
1
n
2
i
)
Here
λ
si the wavelength of the emittted photon
R
is the Rydberg constant, equal to
1.097
⋅
10
7
m
−
1
Plug in your values to find
1
λ
=
1.097
⋅
10
7
.
m
−
1
⋅
(
1
2
2
−
1
6
2
)
1
λ
=
2.4378
⋅
10
6
.
m
−
1
This means that you have
λ
=
4.10
⋅
10
−
7
.
m
So, you know that when an electron falls from
n
i
=
6
to
n
f
=
2
, a photon of wavelength
410 nm
is emitted. This implies that in order for the electron to jump from
n
i
=
2
to
n
f
=
6
, it must absorb a photon of the same wavelength.
Explain in detail how low density polyethylene is made
Answer:
Low-density polyethylene is manufactured by the process of the polymerization of ethylene at very high temperatures in a tubular reactor. In this tubular reactor, high-pressure polymerization allows further copolymerization of ethylene with polar co-monomers. The tubular process has an advantage over autoclave process.
Explanation:
please mark brainliest
Make a
prediction about how a lack
of resources in an ecosystem
might impact the levels of
organization.
Answer:
Limiting factors of an ecosystem include disease, severe climate and weather changes, predator-prey relationships, commercial development, environmental pollution and more. An excess or depletion of any one of these limiting factors can degrade and even destroy a habitat.
Explanation:
The limiting factor of an ecosystem involve disease, weather change, climate change, environment pollution and more. An excess or depletion of any of these factor can destroy over habitat.
What is Ecosystem?An ecosystem is define as a community or a group of living organisms that live together and are dependent on each other.
There are two main types of ecosystem.
Terrestrial ecosystem-Terrestrial ecosystem are land based ecosystem and interaction of biotic and abiotic component in the specific area.
Example- forest, grassland desert etc.
Aquatic ecosystem-Aquatic ecosystem are ecosystem formed by surrounding water bodies. They are dependent on each other and their environment .
Example- lake, pond, river etc.
Thus ecosystem and their limiting factor have great impact on the level of organization.
To learn more about ecosystem, refer to the link below:
https://brainly.com/question/13979184
#SPJ2
Help asap pls! Circulating air caused when warm air rises and cool air sinks. Convection currents occur throughout the world.
1.barrage 2.collection area 3.convection current
3. Convection Current
But just a tip Next time try to emphasize the question a little more ! Hope this helps :)
1120 KG car is traveling with a speed of 40 M/S find its energy
Answer:
252 Joules
Explanation:
I thin k this is right, im so sorry if not!! :)
Help hurry please !!!!!
We measure force in units called
HELP PLEASEEEEEE ASAP
A condition in which bones become weak and brittle.
The body constantly absorbs and replaces bone tissue. With osteoporosis, new bone creation doesn't keep up with old bone removal.
thus 2) is correct.
a disease in which bone tissue becomes breakable and thin.
if it helps don't forget to like and Mark me
How many grams of calcium chloride would be dissolved in 1.0L of a 0.10m solution of calcium chloride?
Answer:
2365 g
Explanation:
My teacher laid this much out for us but I don’t know how to get the products in each one.
Answer:dang
Explanation:
The analysis in this experiment assumes that CO2 is an ideal gas. Select the answer below that best explains if CO2 is an ideal gas and why. Group of answer choices CO2 is an ideal gas; this is because it is polar. CO2 is not an ideal gas; while it is nonpolar, the molecules do attract and repel each other, they also take up space- two characteristics that an ideal gas does not have. CO2 is not an ideal gas; it is polar, the molecules strongly attract and repel each other, they also take up space- two characteristics that an ideal gas does not have. CO2 is an ideal gas; this is because it is nonpolar.
The nucleus inside a eukaryotic cell has ________ that contains cell's DNA.
A. bacteria
B. chromosomes
C. electron
O D. hair
show by means of equations how to separate mixture of benzoic acid and phenol
Just dissolve all three compounds in an organic solvent which not miscible with water (those two I have mentioned) in separatory funnel. Use aqueous sodium bicarbonate first to extract. If you use sodium hydroxide, both phenol and benzoic acid will be extracted as both can react with hydroxide