How does adding a resistor to an electric circuit affect the current? (1 point)

O The resistor increases the current by increasing the amount of electric charge.

O The resistor decreases the current by decreasing the amount of electric charge.

O The resistor increases the current by transforming light energy or heat into electrical energy

O The resistor decreases the current by transforming electrical energy into different types of energy

Answer:

Mechanization   perhaps

Explanation:

Answer:

a variant can cause a protein to malfunction or to not be produced at all.

Answer:

0.25 m

Explanation:

 λ = v/f

I hope it helped you

Answer:

Distance between them  (r^2 )

Explanation:

F = C q1q2/r^2

Answer:

C is radius of sphere

Explanation:

F is C/2

The speed of the sound wave after the flash was seen, in the experiment for measuring the speed of sound gun is 110 m/s.

The speed of the sound wave can be determined by applying the principle of echoe as shown below;

v = 2d/t

where;

v = (2 x 715) / (13)

v = 110 m/s

Thus, the speed of the sound wave after the flash was seen, in the experiment for measuring the speed of sound gun is 110 m/s.

Learn more about speed of sound here: https://brainly.com/question/15211242

Answer: The Energy Change

Explanation: change for a chemical reaction can either be exothermic if it gives off heat or endothermic if it requires heat to proceed.  in a chemical reaction is due to the difference in the amounts of stored chemical energy between the products and the reactants. This stored chemical energy, or heat content, of the system is known as its enthalpy. energy changes that occur during a chemical reaction can be shown in a diagram called a potential energy diagram, or sometimes called a reaction progress curve. A potential energy diagram shows the change in potential energy of a system as reactants are converted into products.

F_net:-

Now

Apply Newton's second law

The center of mass is the point located in an average position concerning the objects' positions and their masses. (a/3;a/3) is the location of the COM.  

The center of masses of a given system of particles or objects is the position under which all external forces are acting. Any uniform force acts on this point.

This position is the average position of all the components of the system concerning their masses. It can be placed in one, two or three dimensions according to the system.

Coordinate X of the center of masses is given by the following formula,

Xcom = Σ(Ximi) / Σmi

This is the adition (Σ) of each particle position on the X-axis (Xi) multiplied by their mass (mi), and the result divided by the summation of all masses -total mass-.

In the same way, coordinate Y of the center of masses is given by the following formula,

Ycom = Σ(Yimi) / Σmi

This is the adition (Σ) of each particle position on the Y-axis (Yi) multiplied by their mass (mi), and the result is divided by the summation of all masses.

The center of masses is located in the position (X, Y).

According to this framework, we can get the coordinates of the center of masses for this bidimensional system. Coordinates can be expressed in meters or centimeters (m or cm).

Data:

     Particle ⇒ (X;Y)

Coordinate X  ⇒  Xcom =  Σ(Ximi) / Σmi

                             Xcom =  (0m) + (0m) +(am) / m +m +m

                             Xcom =  am / 3m

                             Xcom =  a/3

Coordinate Y  ⇒  Ycom =  Σ(Yimi) / Σmi

                             Ycom =  (am) + (0m) +(0m) / m +m +m

                             Ycom =  am / 3m

                             Ycom =  a/3

Coordinates of the center of masses, (X;Y) = (a/3 ; a/3)

(a/3 ; a/3) is the location of the center of mass in the proposed bidimensional system.

You can elarn more about the center of mass at

https://brainly.com/question/8662931

https://brainly.com/question/13123609

Answer:

h f = W + KE

Input energy equals work function plus KE of emitted electron

W = 6.63E-34 * 2.5E15 - 6.3 * 1.6E-19

W = 6.63 * 2.5 * 10^-19 - 10.1 * E-19 ev     (1ev = 1.6E-19 J)

W = (16.6 - 10.1)E-19 = 6.5E-19 J

h f = 6.5E-19 J        for electrons to be emitted with zero KE

f = 6.5E-19 / 6.63E-34 = .98E-15 / sec = 9.8E-14 / sec  (threshold)

In my opinion, the relationship between the frequency and the wavelength of sound waves in air is the result of correlation.

Frequency and wavelength are inversely proportional to each other which means if the frequency increases the wavelength decreases and when the frequency decreases, the wavelength increases.

So we can conclude that the relationship between the frequency and the wavelength of sound waves in air is the result of correlation.

Learn more about sound here: https://brainly.com/question/1199084

Daryl's conclusion about the relationship between frequency and wavelength is accurate because this is the result of causation.

Causation implies one factor is the cause of another. For example, plants' need for the sun causes them to grow towards the sun.

On the other hand, correlation occurs if two factors are related and therefore the increase in one factor affects the other. For example, the amount of daylight affects plants' photosynthesis rate.

These two factors are an example of causation because a higher frequency in waaves leads to shorter wavelenghts and vice-versa.

Learn more about causation in: https://brainly.com/question/10971583

Answer:

The earth revolves around the sun in a plane called the ecliptic.

The poles of the earth are at an angle of about 23.5 deg from the ecliptic.

If the north pole is tilted at 23,5 deg towards a perpendicular to this plane (ecliptic) the south pole will be tilted at 23.5 deg away from this plane and will receive the least amount of sunshine.

This is called the summer solstice in the northern hemisphere. and occurs around June 21.

Answer:

Explanation:

I guess so because it has ingredients such as froot loops, frosted flakes, and such plus its liquid.

Answer:

7.481W

Explanation:

power= work done÷time

power= force × uniform velocity

a= ∆v/t

29.0ms=

[tex]29 \times {10}^{ - 3 } s [/tex]

=(0.72-0)÷29×10^-3

a=24.83m/s^2

Newton's second law

f=ma

=(0.84×24.83)

=20.86N

w=FD

v^2=u^2+2as

0.5184=0+49.66s

s=0.0104m

20.86×0.0104

=0.216944J

0.216944÷t

P=7.481W

Answer:

Conduction is the process by which heat energy is transmitted through collisions between neighboring atoms or molecules

Explanation:

Answer:

Voyager 1 and 2

Explanation:

Answer:

Explanation:

The slope of the graph is the spring constant     n/m

Answer:

Thrust / Lift / Gravity

Explanation:

He must create enough force of thrust to jump for a short time and gravity pulls him back down almost immediately.

Answer:

gravity and resistance, the man is moving so the force is unbalanced

Explanation:

Answer:

A, C

Explanation:

It can be found in objects like a swing. It creates kinetic energy when it is coming back or going away, while moving.

Answer:

the answer is equal to the wave make up ultraviolet light.

Answer:

it should be 21,3 kilometer

Answer:

273,000 Astronomical Units.

Explanation:

4.3 light years = 40,850,000,000,000 kilometeres, 4.3 x 9,500,000,000,000.

Convert kilometers to astronomical unit:

149,597,870 kilometers = 1 AU, convert unit.

40,850,000,000,000 divided by 149,597,870 = 273,065.385222 or approx. 273,000 AU.

Answer:

option d is your answer

Explanation:

you can find the complete solution in the given attachment

I hope it helped you

Answer:

b

Explanation:

it indicate direction of baseball

It is true that as the distance d between a planet and a moon is increased, the strength of tidal forces decreases linearly (i.e., the strength of tides scales as 1.

Tidal force is the gravitational force that a body on a linear motion experiences which pull the body towards the center of the mass of another varying body because of the gravitational pull of that body at a distance.

Therefore, It is true that as the distance d between a planet and a moon is increased, the strength of tidal forces decreases linearly (i.e., the strength of tides scales as 1.

Learn more about tidal force below.

https://brainly.com/question/6762160

Explanation:

Parallel circuits are used in wiring almost everything in buildings. You use them to turn on the lights in a room, Use a blow dryer, or plug anything into an outlet

Answer:

w = 40 Joules

Explanation:

Formula to get work:

W = F × S

where:

w = work/Joules

F = force/newtons

s = displacement/meters

substitute:

w = 20 × 2

w = 40J

Answer:

Lift is the upward force on the wing acting perpendicular to the relative wind and perpendicular to the aircraft's lateral axis. Lift is required to counteract the aircraft's weight.

Explanation:

Answer: The upward force acting on the wing of an airplane in flight is called Lift