Answers
Answer:
smaller and further from
Explanation:
Pass light through something clear and light, you'll most likely be able to see all of it's rays spread out, the "normal." Now, pass it through something dense, the amount of light will shrink, therefore be further from the "normal."
Related Questions
What is the meaning of Rusting Of Iron
Plz help me
Answers
Answer:
an oxidation reaction i think that's the answer
Explanation:
Explanation:
Rusting of iron refers to the formation of rust, a mixture of iron oxides, on the surface of iron objects or structures. This rust is formed from a redox reaction between oxygen and iron in an environment containing water.
Hope this helps!!
Have a blessed day <33
How many electrons have been removed from a positively charged electroscope if it has a net charge of 6x10-11?
answer and explain if u can pls :)
Answers
Answer:
is it the ans you are looking for
11. A roller coaster car is moving slowly up a long ramp to the very top of the roller coaster. It goes over the top and starts down a steep slope and it picks up speed rapidly as it rolls down an almost vertical slope. Four seconds later, at the bottom of the steep slope, its velocity is 28 m/s. The average acceleration during those 4 seconds was 6 m/s2 . What was the initial velocity of the roller coaster car as it started down the slope?
Answers
Answer:
a = (v2 - v1) / t
a t = v2 - v1
v1 = v2 - a t
v1 = 28 m/s - 6 m/s^2 * 4 s = 4 m/s
A 3,650.0N car is pushed on the side of the road with a constant motion of 4 m/s. What is the mass of the car?
Answers
a typical 100-watt light bulb consumes 100 j of energy per second. if a light bulb converts all of this energy to 400 nm light, how many photons are produced each second?
Answers
Answer:
Let y equal lambda the wavelength of the light
e (photon) = h f = h c / y
e = 6.63E-34 * 3.0E8 / 400E-9
e = 6.63 * 3 / 400 * 10^-17
e = 4.97E-19
N= 100 J/sec/ 4.97E-19 J = 2.01E20 / sec
which planet has a moon with many sulfur volcanoes?
Answers
Jupiter i hope it is right answer
Determine the pressure due to water at the bottom of a tank which is 25 m deep and 4/5 full of water (density of water = 1000 kgm-3, g = 10 ms-2)
Answers
Answer:
c
Explanation:
ytkjsgxhxkvgakavsvdjddhdbiwbe vs
The pressure due to water at the bottom of the tank is 200000 Pascal.
What is pressure?It is the ratio between the force being applied and the surface area being applied to. The force delivered perpendicularly to an object's surface per unit area across which that force is dispersed is known as pressure.
Given parameters:
Depth of the tank = 25 meter.
Depth of water in the tank: d = 25×4/5 meter = 20 meter.
Density of water: ρ = 1000 kg/m³.
Acceleration due to gravity: g = 10 m/s².
Hence, the pressure due to water at the bottom of the tank
= depth of water (d) × density of water (ρ) × acceleration of the gravity (g)
= 20 meter × 1000 kg/m³ × 10 m/s²
= 200000 Newton/meter²
=200000 Pascal.
Hence, the pressure due to water at the bottom of the tank is 200000 Pascal.
Learn more about pressure, refer the link:
https://brainly.com/question/12971272
#SPJ2
Changing classes, you walk 20.0 m down a hall, turn left, and then walk 10.0 m down another hall. Define a coordinate system and sketch the displacement vector. Also, sketch the displacement components, and then determine the vector's magnitude.
Answers
Explanation:
Calculate position vectors in a multidimensional displacement problem. Solve for the displacement in two or three dimensions. Calculate the velocity vector
What is the density of an object that weighs 500 kg and has a volume of .4 cubic meters ?
Answers
Answer:
1250 for .4
125 for 4
Explanation:
[tex]p=\frac{m}{v}[/tex]
500/4 = 125
500/.4 = 1250
HELP ASAP ILL GIVE BRAINLIST
How are translational, rotational, and oscillatory motion used in the design of various robotic assemblies?
Answers
Answer:
Each of the joints represents a degree of freedom in the manipulator system and allows translation and rotary motion :) Hope this helps
thank you for helppp
Answers
Answer:
the moon is closer to the earth than sun
have a beautiful day
Guys please help me on the rest of the numbers
Answers
Answer:
C. 100
D.3
E. 33.3
Explanation:
C. Mechanical Advantage=Load / Effort
= 200N
--------
100N
Therefore,. = 100
D. I. Velocity Ratio= distance moved by the effort / distance moved by load
= 30cm/10cm
= 3
II. Efficiency= M.A / V.R
= 100/3
= 33.33
If you push on a cart, the force of friction will slow it down. Friction is the conversion of kinetic energy to __________ .
Answers
Answer:thermal energy
Explanation:The friction converts kinetic energy to thermal energy (heat). When two objects are in contact, friction will act with these two objects so this...
Answer:
Heat
Explanation:
Friction always slows a moving object down. ... Friction can be a useful force because it prevents our shoes slipping on the pavement when we walk and stops car tyres skidding on the road. When you walk, friction is caused between the tread on shoes and the ground. This friction acts to grip the ground and prevent sliding.
will the star of bethlehem be visible on december 21st
Answers
Answer:
The best time to view the spectacle on Dec. 21 will be around an hour after sunset.
state the general relationship between temperature and water depth.
Answers
Answer:
Temperature decreases as depth increases (generally)
Explanation:
In general, sunlight will heat the upper level of water. As you go deeper into the water, the sunlight cannot reach as easily so the temperature is lower.
There are exceptions considering underwater currents like the Gulf Stream or volcanic vents.
Two balls are dropped from rest and allowed to fall. If one ball is allowed to fall for 1 s and the other for 3 s compare the distances they have fallen.
Answers
The second ball traveled a greater distance when compared to the first ball because the second ball spent more time in motion.
The given parameters;
time of fall of the first ball, t = 1 stime of fall of the second ball, t = 3 sThe distance traveled by each ball is calculated using the second equation of motion as shown below.
The distance traveled by the first ball is calculated as follows;
[tex]h = u_0t + \frac{1}{2} gt^2\\\\h = 0 + \frac{1}{2} gt^2\\\\h = \frac{1}{2} gt^2\\\\h = (0.5\times 9.8\times 1^2)\\\\h = 4.9 \ m[/tex]
The distance traveled by the second ball is calculated as follows;
[tex]h = \frac{1}{2} gt^2\\\\h = (0.5\times 9.8\times 3^2)\\\\h = 44.1\ m[/tex]
Thus, the second ball traveled a greater distance because it spent more time in motion.
Learn more here:https://brainly.com/question/5868480
NEED HELP!!!! 13 POINTS!!!!!!
Exercise builds muscles because it causes them to contract. If this is the case, would massage, which causes them to relax, also be a way of building muscle?
A.
No, massage does not have any health benefits.
B.
Yes, any working with muscles makes them stronger.
C.
Yes, massage begins when the muscles are very tight.
D.
No, the contraction is where building strength comes from.
Answers
Answer:
If I were you I'd go with B, it just seems to make the most sense to me out of these options.
Write down the relation between force pressure and area
Answers
Answer:
Answer: Pressure is directly proportional to force and inversely proportional to area.
Explanation: Pressure is defined as the ratio of force applied to the area of cross section.
Mathematically,
P=\frac{F}{A}P=
A
F
where,
P = Pressure
F = Force applied
A = Area of cross-section
from above it is visible that pressure is directly proportional to the force applied which means that if force increases, pressure increases. It is also inversely proportional to the area of cross-section. So, when area of cross-section increases, pressure decreases.
The units of pressure are N/m^2N/m
2
and S.I. units for this term is Pascal (P).
The two characterists of stars shown on an H-R diragram are absolute brightness
and
Answers
Surface temperature im quite certain
True or false?
Inertia is related more to acceleration than an object’s mass.
Answers
Answer:
false
Explanation:
false
its making ne type an answer that is 20 characyers long lol
An object has a volume of 100mL and a mass of 200g. What is the density?
Answers
can a system have kinetic and potential energy at the same time
Answers
Answer:
yes
Explanation:
...........................
A Yugo can accelerate from rest to a speed of 28 m/s in 20 s. What is the average acceleration of the car? What distance does it travel in this time
Answers
Answer:
Explanation:
a=28/20
a=1.4 m/s²
V²=v0²+2a.D
28²=0+2x1.4D
784 = 2.8D
D = 280 m
Convert milligram to 1 gram
Answers
Answer:
convert 1 milligram to 1 gram:
Explanation:
1 milligram is 0.001 gram.
so... 2 milligram is 0.002
3 milligrams is 0.003
and so on.
A runner runs at a constant speed of 5 meters per second. They run for 10 minutes (600 seconds). How far did they travel during
those ten minutes?
Answers
300 meters because 5x600=3000 and 3000÷10=300 please someone check me for this answer
What is 4.33 and 2.16?
Answers
what is another name for the magnitude of the velocity vector
Answers
Answer:dddddddddddddddddddd
Explanation:
PLEASE ANSWER ASAP! <33 When the computer you are working on uses energy it also produces waste energy. What type of energy is this waste energy?
Chemical Energy
Thermal Energy
Answers
Answer:
thermal energy
Explanation:
computer produce thermal energy later brought out by exhaust fans...
please mark as brainliest
what 3 things are produced as a result of the fusion of two atoms
Answers
Answer:
Electron, proton and neutron
Explanation:
In each and every atom they are consist of electron, proton and neutron.
Which option is a key point of cell theory?
the answers are
1. Cells are the basic structural unit of all living organisms.
2. Some cells can burn food molecules to release energy, but some cannot.
3. Cells can repair neighboring cells, but not themselves.
4. All cells that make up an organism are similar to each other.
helppppppp I am doing a quiz
Answers
Answer:
1.Cells are the basic structural unit of all living organisms.
Answer:
It has three main parts:
1. All living things are made up of cells.
2. Cells are the basic building blocks of life.
3. All cells come from preexisting cells created through the process of cell division.
Explanation:
As science evolved, three more components were added to the theory. Some biology classes don’t require you to know these parts of the cell theory because they weren’t part of the original definition, but it’s still useful to be aware of them:
4. Energy flow occurs within cells.
5. Hereditary information is passed from cell to cell.
6. All cells have the same basic chemical composition.
So what does the cell theory actually mean? Let’s break it down. The first part of the cell theory states that all living things are made up of cells. Anything that’s alive, from bacteria to plants to humans, is composed of cells. And what are cells? The literal definition is a cell is a group of organelles surrounded by a thin membrane.
The cell theory definition states that cells are the building blocks of life. Cells both make up all living things and run the processes needed for life. Your hair, skin, organs, etc. are all made up of cells. In fact, each person is estimated to be made up of nearly 40 trillion cells! Each part of a cell has a different function, and your cells are responsible for taking in nutrients, turning nutrients into energy, removing waste, and more. Basically, everything your body does, it does because cells are directing the actionThe third part of the cell theory definition states that all cells come from preexisting cells. This means that cells don’t just appear out of thin air (known as “spontaneous generation”). New cells are always made from current cells. This means that all current life on the planet is descended from the very first cells, which first made an appearance on Earth roughly 3.5 billion years ago. Cells have been replicating themselves continuously ever since.
And what does the newer part of the cell theory state? Part four refers to the fact that, in all living cells, energy is continuously transformed from one type to another. Examples of these processes include photosynthesis (where plant cells convert light energy into chemical energy) and cellular respiration (where both plant and animal cells convert glucose into energy). Part five refers to DNA and the fact it is passed from parent cell to child cell. Finally, part six of the cell theory tells us that all cells are made up of the same chemicals: water, inorganic ions, and organic molecules.!