Answer:
The initial energy emission occurs by 80% or more in the form of gamma rays but these are quickly absorbed and dispersed mostly by air in little more than a microsecond, converting gamma radiation into thermal radiation (thermal pulse ) and kinetic energy (shock wave) which are actually the two dominant effects in the initial moments of the explosion. The rest of the energy is released in the form of delayed radiation (fallout or fallout) and is not always counted when measuring the performance of the explosion.
Explanation:
High altitude explosions produce greater damage and extreme radiation flux due to lower air density (photons encounter less opposition) and consequently a higher blast wave is generated.
How does a transistor work?
i need three examples !
Answer:
A transistor works when the electrons and the holes start moving across the two junctions between the n-type and p-type silicon. ... By turning a small input current into a large output current, the transistor acts like an amplifier. But it also acts like a switch at the same time.
Explanation:
Which statement best defines work.
A) Work is the time it takes to move an object once acted upon by a force
B) Work occurs when balanced forces act on a object and cause movement in the direction of these forces
C) Work occurs when a force causes motion of an object, and this motion is the same directional the applied force
D) Work is the distance over time that an object moves once acted on by a force
Subduction zones are found at ________ plate boundaries. *
5 points
ocean to continental convergent
Transform
ocean to continental divergent
continental to continental divergent
Answer:
A. Ocean to continental convergent
14. Give an example of condensation.
Condensation is the water on the outside of a cold cup of water on a hot day.
A dolphin swims 1.85 km/hr how far has the dolphin traveled after 0.6 hours
A 1.11km
B 3.08km
C 0.32km
D 1.85km
Answer:
The answer is option AExplanation:
In order to find the distance covered we use the formula
distance = velocity × timeFrom the question
velocity = 1.85 km/hr
time = 0.6 hours
We have
distance = 1.85 × 0.6
We have the final answer as
1.11 kmHope this helps you
A student is standing on a very steep hill, kicks a soccer ball horizontally with a speed of 10 m/s toward a student who is sitting on a level field 3 meters below. How long does it take the soccer ball to strike the ground?
Answer:
0.782 seconds
Explanation:
We are given that the ball starts out on a hill that is 3 m above a level field below. And that the ball is kicked horizontally. We are asked how long the ball takes to hit the ground 3 meters below.
On closer consideration of the given situation, it is important to realize that even though the ball starts out with a speed of 10m/s in the horizontal direction, that this will not make a difference in how fast the ball travels in the vertical direction (which is what the question is basically asking for). Hence for this question, we can ignore the initial horizontal speed of the ball and realize that the initial vertical speed is 0 m/s.
Recall that one of the equations of motion can be expressed as:
s = ut + (1/2) at² (refer to attached for reference)
where,
Applied in the vertical direction,
s = vertical distance travelled = 3 meters in this case
u = initial vertical velocity = 0 m/s in this case
a = acceleration due to gravity, g = 9.81 m/s²
t = time taken ( we are asked to find this)
simply substituting the known values above into the equation:
s = ut + (1/2) at²
3 = 0 + (1/2) (9.81)t²
3 = 4.905t²
t² = 3 / 4.905
t² = 0.61162
t = √0.61162
t = 0.782 seconds
scientific findings that prove the strong nuclear force exsist
Answer: The strong nuclear force is one of the four fundamental forces in nature; the other three are gravity, electromagnetism and the weak force. As its name implies, the strong force is the strongest force of the four. It is responsible for binding together the fundamental particles of matter to form larger particles
1. A skateboarder is skating over a circular bump. He is at the top of the bump and is
moving rightward. Is the normal force exerted on the skateboarder by the bump greater
than, less than, or equal to the weight of the skateboarder? Explain your reasoning.
Answer:
The normal force exerted on the skateboarder by the bump is less than the weight of the skateboarder
Explanation:
The given parameters are;
The location of the skateboarder = The top of the circular bump
The direction of motion of the skateboarder = Rightward
Therefore, given than the skateboarder has both horizontal angular motion (moving rightward) and vertical angular motion (over the bump), The effect of the weight of the skateboarder on the ground is reduced by the centripetal forces acting on the skateboarder and the normal force exerted on the skateboarder by the bump is equal to the reduced weight and is therefore less than the actual weight of the skateboarder.
The normal force exerted on the skateboarder is less than the weight due to the effect of centripetal force.
Given data:
The position of skateboarder is at top of the circular bump.
And direction of motion of Skateboarder is towards rightward.
Since, the skateboarder is undergoing the motion over the circular path, then it will have both horizontal angular motion (moving rightward) and vertical angular motion (over the bump).
The effect of the weight of the skateboarder on the ground is reduced by the centripetal forces acting on the skateboarder and the normal force exerted on the skateboarder by the bump is equal to the reduced weight and is therefore less than the actual weight of the skateboarder.
Thus, we can conclude that the normal force exerted on the skateboarder is less than the weight due to the effect of centripetal force.
Learn more about the centripetal force here:
https://brainly.com/question/14249440
The force needed to stop an object in motion is called?
force called friction
The force applied to object to stop its motion is known as frictional force.
Newton's first law of motion states that an object in a state of rest or uniform motion in a straight line, we continue in that form unless it is acted upon by an external force. This reluctance of an object to move or stop moving is known as the object's inertia. This inertia depends on the mass of the object.
When an object is finally in motion, the friction, between the object and the surface on which it is moving tends to limit the motion.
Thus, to stop an object in motion, we increase the frictional force between the object and the surface on which the object is moving
Learn more here: https://brainly.com/question/12012843
is it possible that during the big bang the laws of physics changed?
Answer:
yes, so many answers to that like possibilities
Explanation:
i watch a movie
Problem
Position The figure shows a motorcyclist traveling east along a straight
road. After passing point B, the cyclist continues to travel at an average
velocity of 18 m/s east and arrives at point C2.8 s later. What is the
position of point ?
Answer:
s = 50.4 m
Hence, the point C is 50.4 m towards east from point B
Explanation:
Since, the motorcyclist travels at a constant speed in straight line towards east after point B. Therefore, we can use the following equation in this case:
s = vt
where,
s = distance covered = position of point C = ?
v = uniform speed of motorcyclist = 18 m/s
t = time interval = 2.8 s
Therefore,
s = (18 m/s)(2.8 s)
s = 50.4 m
Hence, the point C is 50.4 m towards east from point B
A bus trip covers 191 km and takes 4 hours and 15 minutes. What is the average speed of the bus in kilometers per hour?
Answer: 46 kph
Explanation:
191 ÷ 4.15 = 46.02
It might not be right
When soda bottles are sealed in a factory, the bottles are all the same temperature with the same pressure of gas inside. A student decides to perform an experiment to determine what changes will result from adjusting the temperatures of two sealed soda bottles. One bottle of soda is heated, while the other is cooled.
Which statement describes a result of the experiment?
Answer: changes will result from adjusting the temperatures of two sealed soda
Explanation:
the preasure builds up and makes the bottle expand so it might crack but the other one will become ice then will crack the sides
Answer:
changes
Explanation:
A bus travels at a constant speed of 40.0 m/s for .8h. Whats the total distance travelled in km.
Answer:
1,152 km. Hope this helps!
Explanation:
Explain the energy needed for a liquid to evaporate into gas
Which two chemists organized elements based on properties such as how the elements react or whether they are solid or liquid?
Lavoisier and Mendeleev
Döbereiner and Newlands
Newlands and Mendeleev
Lavoisier and Döbereiner
Answer:
The chemists that organized elements based on properties such as how the elements react or whether they are solid or liquid are Lavoisier and Dobereiner
Lavoisier basis of theory is on the various properties of metals, nonmetals and gases.
Dobereiner gave the law of triads. In this theory the middle element is the average of the other two elements.
Answer:
d. Lavoisier and Döbereiner
Explanation:
What type of landform is depicted here? a. a mountain b. a depression c. a valley
Answer:
b.mountain the correct answer
Explanation:
what type of ladform ids depicted here? a.a b. mountain b. a depression c. avaley
What is the name of the system for conducting a scientific investigation?
1. Comparative analysis
2. Scientific Method
3. Evaluation Process
4. Trial by error
Answer:
i beleive it is 2
Explanation:
Jim traveled the first 3 hours of his journey at speed of 60 mph and the remaining 5 hours at 24 mph. How long is the whole journey in miles?
Answer:
300 miles
Explanation:
3*60 + 5*24 = 300
The photo shows a person pumping gasoline into a car
Which TWO of these energy transformations will occur when the car’s engine starts?
A. Chemical energy —> thermal energy
B. Chemical energy —> mechanical energy
C. Mechanical energy —> Chemical energy
D. Thermal energy —> chemical energy
_____________________
Choose TWO
Answer:
It is CHEMICAL TO MECHANICAL because gas is a chemical which is transferred to mechanical technologies
Answer:
The first one is ^^
The SECOND one is chemical energy to thermal energy
You're welcome for getting wrong so that you can now get it right :|
When we look at a book in the sunlight, what must happen to the light for our eyes to see the book?
Answer:
Sometimes you can see light from the Sun passing through clouds and the sunbeams appear as straight lines. After light has been reflected off an object, such as a tree or a book, it still travels in straight lines, but in a new direction.
Explanation:
A bowling bowl rolls 33m with an average speed of 2.5 m/s how many seconds did the ball roll
which of the following includes an example of a chemical property of an element?
a. aluminum is solid at room temperature
b. sulfur is not shiny and is not malleable
c. sodium is a solid at room temperature and reacts to other elements.
d. silicone is shiny and is a poor conducted of electricity
Answer:
d. silicone is shiny and is a poor conducted of electricity
The best option that describes an example of a chemical property of an element is silicone is shiny and is a poor conductor of electricity. Option D is correct.
The chemical properties of elements are those properties that are noticeable during the course of a chemical reaction.
Aluminum is solid but not at room temperature. The elements that are solid at room temperature are iron, zinc, gold, and silver. Hence option is incorrect. The same is applicable to options B and C.
The best option that describes an example of a chemical property of an element is silicone is shiny and is a poor conductor of electricity
Learn more here: https://brainly.com/question/19038555
help me guyzz plzz.......
answer:
1.When an electric current is passed through a conductor, the conductor becomes hot after some time and produce heat. This happens due to the conversion of some electric energy passing through the conductor into heat energy. This effect of electric current is called heating effect of current.
2.As per the law of combination of resistances in series,
R=R1 +R2 +R3+R4+R5
R=0.2+0.2+0.2+0.2+0.2
=1ohm
3.power is amount of electrical energy consumed per unit time. Amount of power consumed in a device is proportional to the current flowing in the device. The unit of electric power is watt.
What is the momentum of an object with a mass of 60 kg and velocity of 10 m/s?
Explanation:
Linear momentum= Mass*Velocity
P=mv
P=60*10
P=600Kg m/s
24. What does the atomic number tell you about an atom? What does the mass number tell you about
an atom?
HELP ME ASAPP!
Answer:
Atomic number is the number of protons in the nucleus. The mass number of an atom tells you the total number of protons and neutrons in the nucleus.
in summer, it is cooler in the ground floor than in the top floor of a building. it is because the warm air rises up due to convention. why does warm air rises up?
Answer:
because heat evaporates water
Explanation:
Convert 250 pounds to kg
Answer:
250 pound = 113 kg i guess
A current of 10 A moves through a circuit that contains multiple resistors in parallel. Which statement correctly describes the current through the resistors?
The current through all of the resistors will add up to 10 A.
The current through each resistor will be 10 A.
The current will be greatest through the resistor with the highest resistance.
The current will travel only through the resistor with the least resistance.
Answer:
The current through all of the resistors will add up to 10 A.
Explanation:
what is matter and explain ?
Answer:
It is a physical matter that takes up all things.
Explanation:
By take up i mean structures and properties. Let me know you if have more questions about matter :D