Who was known for being a pilot and an astronaut that walked on the moon?.

Answer:

Explanation:Potential Energy is the stored energy of an object given its position relative to a body. Gravitational potential energy is one type of potential energy and is equal to the product of the object's mass (m), the acceleration caused by gravity (g), and the object's height (h) as distance from the surface of the ground (the body).

mass m of 3 kilograms falling at gravity g of 9.81 meter per second squared from a height h of 5 meters. Solve for potential energy Pe with the equation PE equals m times g times h

In this example, a 3 kilogram mass, at a height of 5 meters, while acted on by Earth's gravity would have 147.15 Joules of potential energy, PE = 3kg * 9.81 m/s2 * 5m = 147.15 J.

9.81 meters per second squared (or more accurately 9.80665 m/s2) is widely accepted among scientists as a working average value for Earth's gravitational pull. This figure is based on a measure of gravity at sea level at a latitude of 45°.

At higher altitudes, gravity decreases slightly.

The effect of latitude on gravitational force is relevant as gravity increases with increasing distance from the Equator. At the Equator, the Earth's gravity is 9.780 m/s2 and at the poles it is 9.832 m/s2 (source: CRC Handbook of Chemistry and Physics).

Gravitational acceleration (to three significant figures) for other planets and bodies in the solar system is as follows:

 m/s2 gn*

Sun 274 27.9

Mercury 3.70 0.38

Venus 8.87 0.90

Earth 9.81 1.00

Moon 1.62 0.17

Mars 3.71 0.38

Jupiter 24.9 2.54

Saturn 10.44 1.06

Uranus 8.87 0.90

Neptune 11.15 1.14

Pluto 0.58 0.06

(table source: NASA)

*Standard gravity (gn). 1.00gn is equal to 9.80665 m/s2

Answer:

light travels slowest in diamond

Explanation:

The higher the index of refraction is, the slower the speed of light is. The indexes of refraction for diamond, air, and glass are, respectively, 2.42, 1.00, and approximately 1.50, depending upon the composition of the glass. Light travels slowest in diamonds.

Answer:

Reflection

Explanation:

The particles in the atmosphere only reflect the color blue and and all others are absorbed. Only the reflected colors can be seen from our eyes not the absorbed ones

A fuel injection system that does not use a sensor to measure the amount (or mass) of air entering the engine is usually called speed density type of system.

Speed density fuel injection system is a fuel delivery method.

This system relies on a combination of sensor and an intake air temperature sensor to measure the amount (or mass) of air entering the engine.

Thus, a fuel injection system that does not use a sensor to measure the amount (or mass) of air entering the engine is usually called speed density type of system.

Learn more about speed density here: https://brainly.com/question/26024294

Answer:

M a = (M1 + M2) a = F         Newton's Second Law

F = (M2 - M1) g         net force on the system

a = (M2 - M1) / (M1 + M2) g

a = (9 - 7) / (9 + 7) g = 2 / 16 * 10.0 m/s^2 = 1.25 m/s^2

Answer:

see below

Explanation:

P1V1 = P2V2

100 000 (.03)  = x ( .025)     x = 120 000 pa

Answer:

Two objects are moving in opposite direction on a straight line. After collision, they stick together and move with common velocity

The total momentum of a colliding system is constant always. Therefore, by using this concept, the final velocity of the coupled mass will be 3.7 m/s.

Momentum of an object is the ability of an object to bring the force applied to make a maximum displacement. It is the product of its mass and velocity. Momentum is a vector quantity. It have both magnitude and direction.

The momentum in a collision is conserved. Thus total initial momentum is equal to the final momentum. Let m1 and m2 be the colliding masses and the u and v be the initial and final velocity.

Then, m1 u1 + m2u2 = (m1 + m2)v for a coupled mass after collision.

then final velocity v =  ( m1 u1 + m2u2 )/ (m1 + m2)

Apply the given values in the equation as follows:

v = (0.25 kg ×3.4m/s + 0.45 kg× 3.9 m/s)) (0.45 + 0.25) = 3.7 m/s

Therefore, the final velocity of the coupled masses after collision is  3.7 m/s.

Find more on momentum:

http://brainly.com/question/24030570

#SPJ2

The  friction between the tires and the road causes loss of energy in the form of heat-energy.

The term kinetic energy refers to the energy of an object that is in motion. The pasengers that are sitting at a point possess potential energy. If the bus stops suddenly, the potential energy of the passengers is converted to kinetic energy as they move forward.

Since friction causes loss of energy, the  friction between the tires and the road causes looss of energy in the form of heat-energy.

Learn more about kinetic energy: https://brainly.com/question/12669551

#SPJ4

Explanation:

A)   PV = n RT    

  2*  ( 1)  =  .5 (.082057)(T)       T is in Kelvin

    T = 48.7 K

B) PV = nRT

  3 *  V = 4 ( .082057)(200)

          V = 21.88 Liters

C) PV = nRT

   3.5 (5) = n (.082057)(275)    n = .776 moles

Answer:

Copper

Explanation:

Capacitance is directly proportional to dielectric constant

Aluminium and zinc are highly reactive and have high dielectric contact.

Copper has less dielectric constant hence capacitance will decrease

Answer:

Climate

Explanation:

conditions of the atmosphere at a particular location over a long period of time; it is the long-term summation of the atmospheric elements

Answer:

NICE HANDWRITING. I've done this before and I'm sure everything is correct. Although I would re-check to see if you had any mistakes with your calculations. Good job!

Explanation:

The statement "A schema is a cluster of beliefs that allow one to process information about people,  emotions, and events." is true. This is further explained below.

Generally, Schema is simply defined as a cluster of beliefs that allow one to process information about Humans, emotions, and events.

In conclusion, a cluster of beliefs that allow one to process information about Humans is a  Schema

Read more about Humans

https://brainly.com/question/18540902

#SPJ4

Answer:

true

Explanation:

Answer:

Volt divided by ampere

Explanation:

V = IR

V/I = R

The unit of resistance from ohms law is volt / ampere. Thus, option A is correct.

Ohm's law states that the applied voltage is directly proportional to the current flow in the conductor. It is written as V ∝ I. It remains constant at room temperature.

V is defined as  potential difference or voltage. The SI unit of voltage is volt(V). I is defined as the current flowing in the circuit. The SI unit of current is ampere (A).

Generally, ohm's law equals to V = IR. R represents resistance of a material which oppose the current flow in the conductor. The unit of resistance is ohm(Ω).

When the potential difference(V) is constant, Resistance is inversely proportional to current. Current increases with decrease of resistance and current decreases with increase of resistance.

To find  equivalent unit of resistance, the ohm's law is :

V = IR

R = V / I

  = volt / ampere.

Hence, the unit of resistance from ohm's law is volt / ampere. The SI unit of resistance is ohm(Ω). Thus, option A is correct.

To learn more about Ohm's law:

https://brainly.com/question/1247379

#SPJ7

Answer:

Because collisions are constantly occurring within the ring systems, ring particles are continually being ground down to dust.

Explanation:

Answer:

According to studies, the milky way is approximately, "170,000–200,000 light-years (52–61 kpc) in diameter and, on average, approximately 1,000 ly (0.3 kpc) thick."

With that being said, it is safe to say that the dimensions are somewhere around 100,000 by 1,000

Jasmine need to correct the error by switching the headings on the columns adding the title parallel circuits.

A parallel circuit is a circuit in which the components are connected to a common junction. This implies that if one bulb goes out in a parallel connection, all the bulbs will go out.

As such, Jasmine need to correct the error by switching the headings on the columns adding the title parallel circuits.

Learn more about parallel connection: https://brainly.com/question/12400458

#SPJ4

The energy a photon of the orange light carries is 3.32 eV.

The energy possessed by the photon incident on a surface is the energy of the photon. It is denoted by [tex]E[/tex].

Energy is related to frequency as

[tex]E=h\nu[/tex]

where h is the plank's constant, [tex]h = 6.626 \times10^{-34} \; \rm Js[/tex]

[tex]\nu=5.01\times10^{14} \:\rm Hz[/tex]

Energy will be

[tex]E= 6.626 \times10^{-34} \times\55.01\times10^{14}\\E=\333.2\times10^{-20} \rm J[/tex]

Given,

[tex]1\rm eV = 1.60 \times 10^{-19} \rm J[/tex]

Energy in eV is

[tex]E=\frac{33.2\times10^{-20}}{ 1.60 \times 10^{-19} \rm J} \\E=3.32 \rm eV[/tex]

Therefore, the energy of the photon in eV is 3.32 eV.

Learn more about the energy of a photon.

https://brainly.com/question/2393994

#SPJ1

Answer:

see below

Explanation:

voltage = current * resistance

stick is like a rod

So

[tex]\\ \rm\Rrightarrow I=\dfrac{ML^2}{12}[/tex]

[tex]\\ \rm\Rrightarrow I=\dfrac{2(3)²}{12}[/tex]

[tex]\\ \rm\Rrightarrow I=\dfrac{9}{6}[/tex]

[tex]\\ \rm\Rrightarrow I=\dfrac{3}{2}[/tex]

[tex]\\ \rm\Rrightarrow I=1.5kgm^2[/tex]

Answer:Frequency, Intensity, Time, Type

Explanation: frequency, intensity, time, and type is one way to remember the general guidelines for what should be included in a fitness plan.

Answer:

64q

Explanation:

Note that

Here

Capacitance C and potential V is given

We know

So charge is also same

Now

there are 64 drops so 64q charge

Answer:

a round shape. It has its own gravity to pull itself into a round shape

When the original resistor is replaced with 3 times more resistive material, the resistance of the circuit increases by factor of 3 and  the current flowing in the cirucit decreases by a factor 3.

Ohm's law states that, the current flowing in a conductor is directly proportional to the potential across the conductor.

V = IR

where;

When the resistance increases, the current flowing in the circuit decreases.

When the original resistor is replaced with 3 times more resistive material, the resistance of the circuit increases by factor of 3 and  the current flowing in the cirucit decreases by a factor 3.

Learn more about ohm's law here: https://brainly.com/question/231741

This question involves the concepts of th magnetic field and current.

The magnetic field created by the current at the house is "6.75 x 10⁻⁷ T".

The magnetic field created by a current carrying wire can be given by the following formula:

[tex]B=\frac{\mu_o I}{2\pi r}[/tex]

where,

[tex]B=\frac{4\pi x\ 10^{-7}(152)}{2\pi(45)}[/tex]

B = 6.75 x 10⁻⁷ T

Learn more about magnetic field here:

https://brainly.com/question/23096032

#SPJ1

Answer:

Wave3 = slowest

Explanation:

Wave 3 will move the slowest

in liqiud and solids the molecules are closer together so the waves propogate faster than in a gas