Answer: Not possible to find average amu with only the information provided.
Explanation:
Is there more information about the other isotopes? I don't see how one could calculate an overall atomic mass with only one isotope is known. An isotope of 186.956 with abundance of 62.6% isn't enough information. We're not told anything about the other isotopes: are they larger, smaller, and at what percentage. If one has an amu of 204.956 at 37.4%, the overall atomic mass would be quite different than if it had an atomic mass of 182.956 at 37.4%. More infornmation is required.
While Brian was cutting the end of the rubber tube, during chemistry lab, he accidently cut his finger. It was a minor cut and hardly any blood was visible. Brian should __________
a. tell his teacher immediately and do as directed.
b. go to the sink and wash his hand with soap and water.
c. place a towel over the wound and keep working.
d. continue working because he is ok.
Answer:
A because even if its a minor cut, it's always a better choice to inform someone.
solar powered cars use energy use energy form the sun to work. a panel on the car absorbs light energy from the sun, which then generates a electric current. this electric current, in turn allows this car to move. which shows the correct order of energy transformations that take place in a solar-powered car? A. electrical, chemical, kinetic B. electrical, kinetic, radiant C. radiant, chemical, electrical D. radiant, electrical, mechanical. i will brainliest to fastest answer
Answer:
The answer is
D)
radiant, electrical, mechanical
Explanation:
Use the information about igneous rocks A-D to classify each one as intrusive or extrusive and basaltic or granitic. Fill in the
chart with A, B, C, or D.
Rock A-dark-colored large grains
Rock B-large crystals, high percentage of silica
Rock C-fine-grained texture, light-colored
Rock D—from Hawaiian volcano area, no visible crystals
Extrusive
Intrusive
1.
2.
Basaltic
Granitic
3.
4.
Answer:
1. D 2.. A 3. C 4. B
Explanation:
just took the quiz
We can classify each rock as intrusive or extrusive and basaltic or granitic as follows; Rock A - Extrusive, Basaltic, Rock B - Intrusive, Granitic, Rock C - Extrusive, Basaltic, and Rock D - Extrusive, Basaltic.
Rock A - Extrusive, Basaltic
Rock A is described as having dark-colored large grains, which indicates a fine-grained texture, typical of extrusive rocks. The presence of dark-colored large grains suggests a basaltic composition.
Rock B - Intrusive, Granitic
Rock B is described as having large crystals and a high percentage of silica, which suggests a coarse-grained texture, typical of intrusive rocks. The high silica content and large crystals indicate a granitic composition.
Rock C - Extrusive, Basaltic
Rock C is described as having a fine-grained texture and being light-colored, which are characteristic features of extrusive rocks. The fine-grained texture suggests a rapid cooling, typical of extrusive rocks, and the light color is indicative of a basaltic composition.
Rock D - Extrusive, Basaltic
Rock D is described as being from the Hawaiian volcano area and having no visible crystals. This indicates a glassy texture, typical of rapidly cooled extrusive rocks. The origin from a volcanic area and glassy texture suggest a basaltic composition.
To know more about extrusive rocks here
https://brainly.com/question/1810304
#SPJ3
How many Joules of energy are needed melt 40.0 g of ice?
answer: 334 J
explain: A total of 334 J of energy are required to melt 1 g of ice at 0°C, which is called the latent heat of melting.
Could someone help me pls
Answer:
a) dispersion
b) draw the path ray of green light between the red and violet path rays
c) greater/faster
Explanation:
b) Order of rainbow colours:
RedOrange YellowGreenBlueIndigoVioletc) Violet is the most refracted colour while red is the least refracted colour; the colour with a greater speed is the most refracted
Please DO NOT ANSWER if you don't know and don't copy and paste from the internet
which is stronger, ionic bonding or covalent bonding? and why
I think so the answer would be Ionic Bonding
Im not sure
Answer:
ionic bonding because of the coulombic attraction between ions of opposite charges.
Can someone solve this question? I'll give brainliest and more points.
Answer:
When a substance undergoes a chemical change it is no longer the same but a burning substance.
Explanation:
That is the correct answer.
Do gasses have a fixed volume
Answer:
No
Explanation: Gases have no fixed volume and no fixed shape. Gases expand to fill the space available. They can also be compressed into a very small space.
What does this picture represent?
A.
Volumetric flask
B.
Erlenmeyer flask
C
Graduated cylinder
D.
Beaker
Answer:
The answer is D.) Beaker. Hope this helps! :)
Physical Models Activity (I need help)
You have explored some interesting, informative, and amusing examples of models. Now it's time to get creative and make your own model. Here is the requirement checklist for your model:
✔ Model types can include drawings, diagrams, physical models, virtual simulations, or videos.
✔ Models must be created by you, not something selected from an online or outside source.
✔ Submit a presentation, picture, video, or screenshot of your model.
✔ Submit a one-paragraph summary describing the topic you chose, your model, what it represents, how you made it, and the specific science involved. It is important that you are using science terminology and are accurate.
Now that you know how to create and submit your model, you will need to choose a topic for your model. Choose one of the three topics listed below. Select each topic for an overview.
Conservation of Mass
Atomic Theory
Thermal Energy
The question above wants to assess your ability to create a model to represent a scientific concept. In that case, I can't create the model for you, but I'll show you how to create that template.
First, you must choose one of the topics presented in the question. I suggest that you choose the topic "Conservation of Masses," because of its simplicity, however you should choose the one you are most familiar with.
Next, you should research this topic and look at the factors that make it up.
After that, you can create your template as follows:
Use a software that has ready-made drawings, mainly geometric figures, for you to represent the elements that make up this topic.Use these drawings to represent these elements, place titles that identify them, and add arrows, which direct the viewer's attention to understand the model.You can see examples of "Conservation of Masses," models in the attached figure.
More information:
https://brainly.com/question/22254694?referrer=searchResults
Determine the number of atoms in the following chemical formulas.
1. Naci
Answer:
2 atoms
Explanation:
a sample of gold has a mass of 96.5 g and a volume of 5.00 cm3. the density of gold is
Answer:
19.3 g/cm³Explanation:
The density of a substance can be found by using the formula
[tex]density = \frac{mass}{volume} \\[/tex]
From the question
mass = 96.5 g
volume = 5 cm³
We have
[tex]density = \frac{96.5}{5} \\ = 19.3[/tex]
We have the final answer as
19.3 g/cm³Hope this helps you
What type of front is depicted here? (60 Points)
Cold
warm
stationary
Occluded
Answer:
warm
Explanation:
Who discovered the proton?
Crookes
Rutherford
Balten
Chadwick
Answer:
Sir James Chadwick discovered proton
Explanation:
Sir James Chadwick, was a British physicist who was awarded the 1935 Nobel Prize in Physics for his discovery of the neutron in 1932. In 1941, he wrote the final draft of the MAUD Report, which inspired the U.S. government to begin serious atomic bomb research efforts.
HELP FAST PLEASE !!!!
Explanation:
See the table above. Periods at the side, metals at the top, non metals to the right, group to the right of that
What did Thomson contribute to atomic theory?
A. The discovery that positive charge is concentrated in a core, or nucleus
B. The discovery that negative charge is concentrated in a core, or nucleus
C. The discovery of negatively charged particles, now called electrons
D. The idea that electrons have quantized amounts of energy
based on the dosages a patient receives what level of precision should a syringe have to ensure that the patient receives the proper dosage
Answer:
No.
Explanation:
The person giving the dosage should make sure there is a proper dosage. The syringe only tells you how much there is in the syringe.
what is always formed when a strong acid solution reacts with a strong base solution?
Answer:
water and salt
Explanation:
A neutralization reaction is when an acid and a base react to form water and a salt and involves the combination of H+ ions and OH- ions to generate water. The neutralization of a strong acid and strong base has a pH equal to 7.
Hope this helps
PLS MARK BRAINLIEST
5 Facts about Geology
what are the conditions from our notes that affect natural Selection?
Answer:
Conditions that affect natural selection are reproduction, heredity, variation in fitness or organisms, variation in individual characters among members of the population. If they are met, natural selection automatically results.
How many grams of H2O is needed to produce 0.75 moles of ?
Answer:
H2O2 + H2S → 2H2O + S? that is the answer
what is the formula of the ionic compound that forms from gallium and chlorine?
Answer:
GaCl3
Explanation:
Gallium trichloride | GaCl3 |
Answer:
GaCl3
Explanation:
identify two ways in which carbon-12 carbon-13 and carbon-14 are alike
Answer:
identify two ways in which carbon-12, carbon-13, and carbon-14 are alike. they each have 6 protons and neutrons and they're all carbon atoms. what is a chemical compound?
PLZZ HELP
Which of the following Is acompound?
Ne
N₂
Naci
02
Answer:
[tex]N2[/tex]
Explanation:
Because
Molecular nitrogen (N2) is a very common chemical compound in which two nitrogen atoms are tightly bound together.
An element in group 2 will form ionic bonds and with
Answer:
With an element from group 16
Explanation:
Because the elements from group 2 have 2 valence electrons, and the elements from group 16 need to get more 2 electrons to get stable
if an atom has 8 protons, 8 neutrons, and 8 electrons and then loses a neutron, what is it?
Answer:
A Cation
Explanation:
ce cantitate se solutie NaOH de cantitate 0.2 M reactioneaza total cu 300g fenol de puritate 90%?
HOPE IT HELPS YOU
CAN YOU BRAINLEST ME
when using a ph meter to monitor a stirring reaction mixture, where should you place the ph sensor electrode?
Answer:Between the stirring vortex and the side of the glassware
When using a ph meter to monitor a stirring reaction mixture, the ph sensor electrode
should be placed;
between the stirring vortex and the side of the glassware.
The pH meter is an electric device that is used to measure the hydrogen-ion activity in water-based solutions. This means that it is used to measure the PH which is the acidity or alkalinity.
The pH meter is made up of a voltmeter attached to a pH-responsive electrode and a reference electrode.
Now, this pH-responsive electrode is usually made of glass while the reference electrode is usually a silver–silver chloride electrode.
Now when monitoring the stirring reaction mixture, the PH-responsive electrode written above is usually placed between the stirring vortex and the side of the glassware.
Read more at; https://brainly.com/question/24242819
how much further apart are water vapor molecules compared to liquid water molecules?
Answer:
At 100 °C (the boiling point of water at standard atmospheric pressure), water molecules in the liquid state have a density of 0.9584 g/cm3. This means that there are 3.21 × 1022 water molecules packed into 1 cm3 and the average distance between water molecules is 3.91 × 10-8 cm.
This is what I found. Hope it helps!
household substances that contains acid
Answer:
milk, lemon juice, toothpaste and baking soda